Connecting to Mohawk Wi-Fi

If a headset is not automatically connecting to Mohawk Wifi (after a factory reset, for example) follow these instructions for connecting:

1. Press  /  on your right Touch controller to pull up your universal menu.
2. Hover over the clock on the left side of the universal menu. When Quick Settings appears, select it to open the Quick Settings panel.
3. Select Wi-Fi.
4. Select the toggle to turn Wi-Fi on, then select the Wi-Fi network you want to connect to (MohawkWifi).
5. Enter the following information:

Username: SOHVR

EAP method : PEAP

Phase 2 authentication : None or MS-CHAP v2

CA certificate: Use system certificate

Domain: mohawkwifi.mohawkcollege.ca

Identity : SOHVR

Anonymous identity : Leave blank

Password : 9&8BH7k2MgTwrxQ

* The ‘SOHVR’ username and password were created as a unique User/Password for the VR Headsets, similar to your Mohawk ID and password. You can also connect to MohawkWifi using the steps above with your personal Mohawk ID Number (Identity) and your personal password, but this is not ideal from a security standpoint.*

For further assistance, please contact HelpDesk@mohawkcollege.ca